Control Panel; Display During Operation; Domestic Hot Water; Turning The Unit On And Off - Ferroli SKY ECO F Installations, Bedienungs Und Wartungsanleitungen

1.2 Control panel

1 2
6 7
1 Key for increasing the DHW
temperature
2 Key for decreasing the
DHW temperature
3 Multifunction display
4 Reset key
5 On/Off key
6 OFF symbol

1.2.1 Display during operation

DOMESTIC HOT WATER

When hot water is requested (using the hot water tap),
the control panel screen will show the current DHW
outlet temperature.
This temperature will increase or decrease as the DHW
sensor temperature reaches the preset value.
In the event of a malfunction (see section 3.4), the LCD
panel will display the error code, along with "d3" and
"d4" during the waiting periods.

1.3 Turning the unit on and off

• Plug the unit into the mains.
• Press the ON/OFF key on the control panel for 1
second.
fig. 2 - Turning the unit off
82
EN
3 4 5
8 9 10
fig. 1 -
7 Burner on and current po-
wer display. When flashing,
this indicates a combustion
fault.
8 DHW operation display
9 Connection for technical
support
10 LCD panel
cod. 3541S170 - Rev. 04 - 09/2019
When the unit is off, the card remains connected. DHW
production is deactivated.
• To turn on the unit, press the key again for 1 se-
cond. The LCD panel will display the version of the
software on the card for the first 5 seconds, followed
by the current DHW outlet temperature.
fig. 3 - Turning the unit on
• Open the gas cock located before our unit. The unit will
operate whenever domestic hot water is demanded.
fig. 4 - In operation

1.4 Adjusting the DHW

• Press the and
temperature between 40ºC and 50ºC. As you can see,
the (ºC) symbol flashes as the adjustment keys are
pressed.
fig. 5 - Minimum temperature
fig. 6 - Maximum temperature
SKY ECO F
keys to adjust the DHW