Carrier 40VCC3 Installations- Und Benutzerhandbuch Seite 16

Operation
7. Local setting:
In the Menu interface, press the UP/DOWN/LEFT/RIGHT keys to move the cursor, and when the setting icon
flashes, press the OK key to enter the interface shown in the figure below. Press the UP/DOWN/LEFT/RIGHT keys
to move the cursor and press the OK key to confirm. The Default Screen Timeout is 15 s, default Brightness is
60%, default Schedule Index is Week, and the default Place is set as Home.
Screen
Timeout
Brightness
Schedule
Index
Place
8. ECO function:
(1) In the menu interface, press the UP/DOWN/LEFT/RIGHT keys to move the cursor. When the ECO icon
flashes, press the OK key to enter; the initial password is 841226. The interface shown in the figure below
will appear. Then, press the UP/DOWN keys to move the cursor and the LEFT/RIGHT keys to adjust the unit/
group. Press the OK key to confirm.
(2) The ECO function by default is set as OFF. The default maximum temperature is 26°C in heating mode, and
the default minimum temperature is 23°C in cooling/dry mode.
(3) Temperature and time value adjustment: When the cursor flashes at a value, press the OK key to stop the
cursor from flashing and press the UP/DOWN keys to adjust the temperature or time value; then, press the OK
key again to confirm and resume the flashing of the cursor and press the UP/DOWN keys to move the cursor.
(4) After setting the ECO function to any group, the temperature of all normal indoor units of the group is set to a
certain temperature.
Setting
Temp/ Range
Type
Selected Unit/Group
Setting
15s 30s
50%
30%
Week
Mall
Hotel
ECO
On
Heat mode
highest temp.
28
limit
No overrun
(Unit 22)
Move cursor, press the Enter key to adjust
1 min 3 mins
60% 80%
Unit/Group
Office
Home
Off
Cool/Dry mode
lowest temp.
limit
12 hrs 30 mins permitted
14
Cancel
23