Deactivating The Rf Transmitter - Dewert RF-Sender BEAM Bedienungsanleitung

GB
Proceed with every single drive system, one after the other, as described under
a)
.
If activation of the
drive from the mains at the wall socket. Wait for
following the procedure described under
d) Deactivating the
Unplug the drive from the mains at the wall socket. Wait for
Then plug the drive back into the mains at the wall socket.
The drive switches to the "
20
BEAM RF transmitter
BEAM RF transmitter
learning mode
has been unsuccessful, unplug the
2 minutes
a) .
" for approx. 20 seconds
, then start again by
2 minutes
2 minutes .
2 minutes
20 seconds
.
07/2008 ID-Nr. 58748