Technical Specifications - cecotec HidroBoost 3200 Induction Pro Bedienungsanleitung

ENGLISH
PROBLEM
The pressure
washer does not
start up
Fluctuating
pressure
The motor stops
suddenly

7. TECHNICAL SPECIFICATIONS

Model: HidroBoost 3200 Induction Pro
Reference No.: 05405
3200 W, 220-240 V~ 50 Hz
Pressure: 15 MPa - 150 bar
28 HIDROBOOST 3200 INDUCTION PRO
CAUSE
• The unit is pressurized
• Plug is not well connected
or electric socket is
defective
• Extension cord is too long
or wire size too small
• Main voltage supply is
too low
• Thermal safety switch
has tripped
• Pump is sucking in air
• Clogged nozzle
• Valves dirty or worn
• Water seals worn
• Extension cord is too long
or wire size too small
• Thermal safety switch
has tripped due to
overheating
SOLUTION
• Squeeze trigger on gun
• Check plug, socket and fuse
• Remove extension cord
• Check that main supply
matches the voltage stated on
the product's rating label
• Switch the device off and allow
it to cool down
• Check that hoses and
connections are tight
• Clean with the cleaning kit
• Contact the Technical Support
Service of Cecotec
• Contact the Technical Support
Service of Cecotec
• Remove extension cord
• Check that main supply
matches the voltage stated on
the product's rating label
Max. pressure: 22.5 MPa - 225 bar
Flow: 7.5 l/min - 450 l/h
Max flow: 9 l/min - 540 l/h
5 ºC - 50 ºC IPX5
Made in China | Designed in Spain