SW-Stahl 23070L Bedienungsanleitung Seite 8

A S S E M B LY K I T F O R PA R K I N G S E N S O R B R AC K E T
The assembly kit is used to replace defective parking sensor brackets or to punch-press holes in
unprepared plastic bumpers. Handle the tools with care and carefully clean the bracket and locator pin
after use.
Lightly grease the screws and threads in the hole punches before use. Please do not use any kind of
compressed air tools to pull the hole punches. Use the hole punches solely on plastics. Using it in other
materials such as metals will destroy the hole punch.
C O N T E N T S :
Item no. Designation
23070L-1 Hole punch ø 18.2 mm
23070L-2 Hole punch ø 18.6 mm
23070L-3 Hole punch ø 26.0 mm
23070L-4 Locator pin, red
23070L-5 Locator pin, silver
23070L-6 Holding fixture, green, 4 units
23070L-7 Holding fixture, blue, 4 units
23070L-8 Holding fixture, silver, 4 units
23070L-9 HSS twist bit ø 10.2 mm
O P E R AT I O N :
Many plastic bumper providers only offer a version without parking assistance. As a result, the holes
for the parking sensors are often missing in the new plastic bumpers. They have to be made first. First
check to see if the positions of the parking sensors are
marked on the plastic bumper. If not, find the positi-
ons with the aid of the repair manual from the vehicle
manufacturer or the plastic bumper manufacturer. The
positioning could look like this:
8