Input voltage
Protection
mode
H1
H2
H3
Note- In the operation of the product, due to pressure drop, the actual
value will have a 0.3V error, which is normal.
Indicator light- The power indicator is red (compressor not work or delay start);
the power indicator is green (compressor work normally) Eco/Max indicator is red
(compressor work on fast cooling system) Eco/Max indicator is green (energy saving
mode)
OPERATION METHOD
The fridge applies electronic temperature control, and the control panel is directly
above cabinet, as shown in the following figure- ON/OFF: connect to the power, press
the ON/OFF button for 3s, then the system will in the ready mode; press the ON/OFF
button for 6s, then the unit will run.
or : press the button or to adjust target temperature. Press the button to
increase or the button to decrease the temperature.
Note- Restore the factory default- In ready mode, press the SET button for 3s, the
screen will show El mark, then press the and at the same time for 3s, the screen will
show "888".At this point, all parameters are restored to the factory default.
12V/DC
Protection
voltage (V)
9.6
10.8
11.8
Start
Protection
voltage(V)
voltage (V)
10.9
11.4
12.4
24V/DC
Start
voltage(V)
21.3
22.7
22.3
23.7
24.3
25.7
5