Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Setting the alarm
The default alarm setting is 06:00.
1. Hold in the [ AL ] until the hour digits flash, then press [ ▲ ] or [ ▼ ] to adjust the hour.
2. Press [ AL ] to confirm and move to the minutes. The minutes digits will flash,
press [ ▲ ] or [ ▼ ] to adjust them.
3. Press [ AL ] to save the alarm time setting and return to normal clock mode. If no button is
pressed for 8 seconds, the clock will automatically return to normal clock mode.
4. A single, short press of the [ AL ] button at any time, will activate/deactivate
the alarm. "AL" is shown on the display when the alarm is activated.
Turning off the alarm
The alarm sounds for a duration of 2 minutes and then turns off automatically.
The alarm can be turned off before the 2 minutes has elapsed by:
1. Pressing [ SNOOZE/DIMMER ], the alarm will sound again after 5 minutes or
whatever time has been set (refer to the Manual time setting section above).
2. Pressing any button except [ SNOOZE/DIMMER ], will turn the alarm off for
24 hours.
Adjusting the brightness of the display
Short presses of the [ SNOOZE/DIMMER ] button will toggle between the display's
two brightness levels.
Care and maintenance
Clean the alarm clock using a lightly moistened cloth. Only use mild cleaning agents,
never solvents or corrosive chemicals.
Troubleshooting guide
The alarm clock loses contact
with the outdoor sensor and
the display shows (- -).
The alarm clock is functioning
abnormally and/or displaying
strange readings.
•
Take in the outdoor sensor and remove
the batteries (this resets the sensor).
Check the batteries and replace if necessary.
Insert new batteries and connect the units in
accordance with the instructions above.
•
The signal from the outdoor sensor is
affected by interference from other electrical
devices, furniture or physical structures.
Try moving the sensor to another location.
•
Press [ RESET ] (12) on the back of the alarm
clock.
8
Werbung
Inhaltsverzeichnis
Fehlerbehebung
