Sensor Unit; Getting Started - Clas Ohlson E0062 Bedienungsanleitung

Sensor unit

14
15
14. LED indicator
15. Wall bracket/stand
16. Outdoor temperature sensor
17. Battery cover
18. Channel selector
19. Battery holder

Getting started

Note: Connect the main unit to a mains electricity outlet (step 1 below) before inserting
the backup battery (step 9). If you insert the main unit's battery first and then connect
it to the mains, it will go into energy-saving mode and will not conduct an automatic
signal search from the outdoor aerial. In this case press [ ▲ ] to conduct a manual search.
1. Plug the mains adaptor into a wall socket and then into the port on the main unit (13).
2. Position the main unit and the sensor next to each other.
3. Remove the wall bracket/stand from the outdoor
sensor if applicable.
4. Open the battery cover on the back of the outdoor
sensor by sliding it in the direction of the arrow.
5. Set the channel selector (18) to channel 1 and insert 2 × AAA/LR03 batteries.
Refer to the markings in the battery compartment to ensure correct polarity.
6. The readings from the outdoor sensor will appear on the main unit's display after
a few seconds.
7. Once the main unit has received a signal from the outdoor sensor, it will
automatically begin searching for a time signal. All buttons and controls will be
inoperative whilst the unit is busy searching for the time signal. The main unit will
be unreceptive to any outdoor sensor signals whilst in search mode.
17
16
5
18
19