General Information; Programming The Remote - Ebode TPC Bedienungsanleitung

Transmitter - Wireless Remote Control
X10 address
The X10 address consists of a House Code and a Unit Code.
In order to control modules via the TPC remote, the receiving
modules need to be set to the same unique X10 address.

General information:

1. The default configuration is set A1 and A2.
This means you can remotely control any X10 compatible receiver which is set
to address A1:
a) Like e.g. the ebode receivers RMA, RMV, RPT, RPA, RPL (RPA
and RPL require a RF transceiver in order to convert the RF
signals to X10 power line commands, e.g the RPT).
b) Or Classic X10 Receivers with rotary address selectors, e.g
TM13, CM15 or SC28 security console, when set to the same
House code, A.
2. The LED's on the front of the remote control show the following state:
GREEN LED: On / bright
RED LED: Off / dimming
Both button rows can control 2 different X10 addresses:
Example as factory set:
First key row: Address A1
Functions: ON / OFF/ DIMMING
Second key row: Address A2 (can be set on any required
X10 address)
Functions: ON / OFF / DIMMING

Programming the remote

ENTER programming mode to change current address
INFO
LED's show the different status as follows :
Red LED for the House code (A to P)
Green LED for the Unit code (1 to 16)
Yellow status to enter and exit programming mode
A. To enter program mode, simultaneously press and hold the On and Off but-
ton until the LED turns yellow. (1 second).
July 2009 page 6
Ref : TPC
TPC