Before The First Use - TriStar AC-5670 Bedienungsanleitung

Instruction manual

BEFORE THE FIRST USE

Before starting operations in this section:
• Find a place where there is power supply nearby.
• Install the exhaust hose and adjust the window position well.
• The supplied small white clips must be mounted on the window
kit.
• Insert the power cord into a grounded AC220-240V~/50Hz
socket.
• Press the power button to turn on the air-conditioner.
• Set the temperature range: 16°C-31°C.
• Check whether the exhaust hose has been mounted properly.
• When using functions on cooling and dehumidifying, allow at least
3 minutes between powering off and powering on.
USING THE ON DEVICE BUTTONS
Cooling operation
• Press the "Mode" button till the "Cool" icon appears.
• Press the + <Temperature up> or - <Temperature down> button
to select a desired room temperature.
• Allow around 5 minutes for the cooling to start.
• Press the "Fan speed" button to adjust airflow speed.
Dehumidifying operation
• Press the "Mode" button until the "Dehumidify" icon appears.
• The temperature will automatically be selected.
• The fan speed will automatically be selected.
Fan operation
• Press the "Mode" button till the "Fan" icon appears.
• Press the "Fan speed" button to adjust airflow speed.
8
Timer operation
Timer ON setting
• When the air-conditioner is OFF, press the "Timer" button and
select a desired ON time and adjust by using the <Temperature
up> and <Temperature down> buttons.
• The ON time can be adjusted to anytime in 0-24 hours.
Timer OFF setting
• When the air-conditioner is ON, press the "Timer" button and
select a desired OFF time and adjust by using the <Temperature
up> and <Temperature down> buttons.
• The OFF time can be adjusted to anytime in 0-24 hours.
Drainage
• After a lengthy operation and before storage, you will need to
drain the water that has been collected. Please prepare a suitable
location or tray to collect the water and remove the rubber stop
from the drainage hole at the bottom of the unit. The water will
then begin to drain. After this has stopped, you can insert the
drain stop.
Internal Tank Water Full Alarm Function
• The inner water tank in the air-conditioner has one water level
safety switch that controls the water level. When the water level
reaches an anticipated height, the water full indicator lamp lights
up. Follow previous steps to drain the water.
INSTALLATION
• The air-conditioner should be installed on a flat and stable
surface. Do not block the air outlet and allow at least 30cm
around the unit.