Troubleshooting - TriStar AC-5670 Bedienungsanleitung

• Open the air inlet grille and take off air filter.
• Clean the air filter with neutral detergent in lukewarm 40°C water
and allow to dry (not in direct sunlight).
• Re-install the air filter into the inlet grille.

TROUBLESHOOTING

Troubles Possible Causes
The unit • Water full indicator
does not lamp blinks and water
start tank is full.
when • Room temperature is
pressing higher than the setting
power temperature.(Electric
button. heating mode)
• Room temperature is
lower that the setting
temperature.(Cooling
mode)
Suggested Remedies
• Drain the water out of the
water tank.
• Adjust the temperature.
The unit • The doors or windows
doesn't are not closed.
cool • There are heat
enough. sources inside the
room.
• Hot air exhaust hose
is not connected or
blocked.
• Temperature setting
is too high.
• Air inlet in blocked.
Noisy. • The ground is not
level or not flat
enough.
• The sound comes
from the flowing of the
refrigerant inside the
air conditioner.
E0 Code. • Room temperature
sensor failed.
E1 Code. • Condenser
temperature sensor
failed.
E2 Code. • Water tank full.
Instruction manual
• Make sure all the
windows and doors are
EN
closed.
• Remove the heat sources
if possible.
• Connect or clean the hot
air exhaust hose.
• Reset the temperature.
• Clean the air inlet.
• Place unit on a flat, level
ground if possible.
• Replace room
temperature sensor.
• Replace condenser
temperature sensor.
• Please empty the water
tank.
11