Ebode PMML Bedienungsanleitung Seite 7

Transmitter & Receiver - Remote Controlled Appliance Kit Ref : PMML
2.2 RMML INSTALLATION OF THE MICRO RECEIVER RMML
The Micro Receiver can be connected either directly to the light fixture
(overhead light, wall lamp, etc.) or behind a power socket.
Lighting Power socket
Antenna Antenna
N N L L
N N L L
Ground wire
Neutral 230V ~ 50 Hz
Neutral 230V ~ 50 Hz
Live 230V ~ 50 Hz
Live 230V ~ 50 Hz
CAUTION
- The LIVE and the NEUTRAL wires are essential.
- For a remote-controlled socket verify the thickness of the back of the socket,
add 25 mm in order to define the minimum depth of the wall box.
Do not connect more lights as the total permitted amount of wattage allows.
1. CAUTION: Shut off power to the circuit in the electrical panel.
2. Press on the top of the terminal board with a screwdriver and insert the wires
(for a light fixture see diagram 1, for a power socket see diagram 2).
Then verify the connections by pulling lightly on the wires.
3. Pull out the antenna as far as you can for better reception.
ACTIVATION
Once the Micro-Modules have been installed connect the circuit switch.
Verify proper operation by pressing the switch's On/Off button. The installation
is done!
July 2009 page 7 PMML