Operation; Before First Use - Princess 282990 Bedienungsanleitung

General
With this attractive Princess Beer Cooler
you can tap the best tasting beer yourself.
At home, but also in the garden for a
barbecue or party. The cooler's insulated
wall ensure that the beer will stay cold for
hours, even without power. The Princess
Beer Cooler is suitable for 5 litre kegs.
As well as for tapping beer, you can also
use the Princess Beer Cooler for keeping
bottles of wine, and cans of beer and soft
drinks cool. Handy if you're on the road.

Operation

See Figure 1.
A tap keg consists of the following parts:
1 Keg
2 Keg tap handle
3 Keg tap pipe
See Figure 2.
The equipment consists of the following
parts:
4 Housing
5 Cover with hand grip
6 Cover block
7 Tap unit
8 Extension pipe (5x)
9 Drip tray will grille
10 12 V DC cable
11 230 V AC cable with plug
See Figure 6.
12 230 V AV connection
13 12 V DC connection
14 Supply voltage selector switch
6 Beer Cooler Article 282990

Before first use

1 Remove all the packaging
2 Clean the appliance and all accessories
(see 'Maintenance and cleaning').
Tapping beer
Position the keg.
See Figure 3.
• The appliance's tap function is only
suitable for 5 litre kegs.
• Read and follow the instructions and
warnings on the keg before you place
it in the appliance.
• Ensure that the keg has been cooled
before placing it in the appliance.
• Always check that the use-by date on
the keg has not expired before placing
the keg in the appliance.
1 Fit the tap handle and the tap pipe that
are supplied with the keg on the keg
according to the instructions on the keg.
2 Slide the extension pipe over the tap
pipe on the keg.
3 Position the tap unit on the keg. Ensure
that the tap handle is in the vertical
position on the keg and protrudes
through the opening in the tap unit.
Then push the extension pipe firmly
onto the underside of the tap unit.
4 Remove the cover from the appliance.
5 Position the keg with the tap unit in the
appliance.
6 Place the cover on the appliance.
7 Place the grille on the drip tray.
8 Position the drip tray against the
appliance. The drip tray is held in place
by two magnets.
9 Slide the supply voltage selector switch
to the required position. 230 V AC or
12 V DC.
10 Connect the 230 V AC cable or the 12 V
DC cable to the associated connection
on the appliance.
11 Push the 230 V AC cable plug into the
wall socket, or plug the 12 V DC cable