Diskashur Pro Led States; How To Use The Diskashur Pro For The First Time - iStorage diskAshur PRO2 Benutzerhandbuch

1. diskAshur PRO
When the diskAshur PRO
2
below.
RED GREEN
Solid Off
Solid Solid
Solid Off
1. In Factory Reset State, the drive is waiting for the operation to set up an Admin PIN.
2. In Brute Force state, the drive is waiting for an operation to get more PIN entry attempts.
3. In Standby state, the drive is waiting for an operation to unlock the drive, or enter Admin mode, or reset the drive.
2. How to use the diskAshur PRO
The diskAshur PRO is shipped with a default Admin PIN of 11223344 and although it can be used straight out of the box
2
with the default Admin PIN, for security reasons we
by following the instructions under section 6 'Changing the Admin PIN'.
Please follow the instructions in the table below to unlock the diskAshur PRO
Instructions - first time use
1. Connect the diskAshur PRO
Standby State
2. In Standby State (solid
down "UNLOCK + 1" buttons
3. Enter the Admin PIN (default - 11223344) and
press "UNLOCK" button
4. Press the "UNLOCK" button once to unlock
diskAshur PRO and access drive contents
2
Note: Once the diskAshur PRO
state and will only blink when data is being transferred. It can be locked down immediately by pressing the 'LOCK'
button once or by
operating system.
#6
LED States
2
is plugged in, there are three possible behaviours for the LED indicators as shown in the table
BLUE diskAshur PRO
Off Factory Reset
Solid Brute Force
Off Standby
highly recommend a new Admin PIN be created immediately
to a USB port -
2
RED LED), press and hold
has been successfully unlocked, the
2
(strongly recommended) clicking the 'Safely Remove Hardware/Eject' icon within your
State
2
1
2
3
for the first time
2
for the first time with the default Admin PIN.
2
LED LED State
RED LED will be solid awaiting PIN entry
Solid
and BLUE
GREEN
for a few seconds then to a solid
finally a solid
diskAshur PRO
Solid
GREEN
the diskAshur PRO
GREEN
www.istorage-uk.com
RED LED will change to blinking
LEDs
and BLUE LEDs blink rapidly together
BLUE LED indicating the
is in "Admin Mode"
2
BLUE LED will change to a blinking
and finally solid GREEN LED indicating
is unlocked
2
LED will remain on and in a solid
GREEN
GREEN and