Olsson Stroot FUN Benutzerhandbuch Und Garantie Seite 21

Keep the electric scooter away from any open flame or other sources of heat to
prevent the battery from getting too hot. Also make sure not to leave the electric
scooter in very cold temperatures.
Both excessive heat and cold can cause the battery to discharge and can damage
it.
Use only the original charger, as each battery requires a specific charger, and if
you use other chargers, this may cause damage to the product.
Do not overcharge or discharge the battery.
Be sure to charge the battery before it runs out of charge, to avoid damaging
the battery cells. (The warranty does not cover the damaged battery caused by
improper use)
Dismantling the battery is prohibited. Can only be handled by the official Olsson
repair service center
BEARINGS, SCREWS, BRAKES AND WHEELS
The electric scooter is made up of moving parts, which over time will be
susceptible to wear.
BEARINGS AND SCREWS
The electric scooter has sealed, dust-proof bearings so lubrication is not
necessary. Check bearing wear at regular intervals to avoid unsafe driving.
Do not go up and down and do not apply excessive force to avoid damaging the
bearings. This is not a sports scooter, it is for children's use.
Make sure that all screws are properly tightened to avoid dangerous situations.
Check the screws regularly and tighten them if they appear loose.
BRAKES
Check the rear brake periodically for wear at regular intervals to avoid unsafe
driving. Do not apply excessive force to avoid damaging the brake.
RUEDAS
Check wheel wear at regular intervals to avoid unsafe driving.
If the wheel appears to bulge even after the bolts are tightened, the bearings may
be worn and require replacement.
EN
21