Maintenance - Strend Pro 7-In-1 Original-Gebrauchsanweisung

c/ Workbench & Sawhorse mode
1. Firstly, set up the legs by following the same steps as detailed
within scaffold mode section.
2. Push the snap buttons on the side of each leg to release them,
then pull the inner legs out to the workbench height. When
legs are fully extended they will snap into place. Gently turn the
workbench upright onto a stable, level surface.
3. Please follow below steps to connect with a quick clamp.
1) Remove the small plastic part of your quick clamp
2) Put the steel bar into our connector (Fig 2) and put a
pin into the lock hole, make sure they are connected
firmly(Fig 3);
3) Put the connector into Sawhorse hole on the
workbench surface and rotate at least 30 degrees
(Fig4);
4) With the help of the 2 vice pegs on the workbench, a
sawhorse is completed.

4/ MAINTENANCE

Maintain your workbench. It is recommended that the general condition of any workbench be examined before it is used. Keep
your workbench in good repair by adopting a program of conscientious repair and maintenance. Have necessary repairs made
by qualified service personnel.
Wipe away dirt and dust from the workbench on a regular basis.
Made in P.R.C.
Snap
button
NOTE: DO NOT step on the workbench while
the legs are fully extended.
20