General Safety Rules - Strend Pro 7-In-1 Original-Gebrauchsanweisung

1/ GENERAL SAFETY RULES

 WARNING: Read and understand all instructions. Failure to follow all instructions listed below may result in serious injury.
 CAUTION: Do not allow persons to operate or assemble this workbench until they have read this manual and have developed a
thorough understanding of how the unit works.
 WARNING: The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions
or situations that could occur. It must be understood by the operator that common sense and caution are factors
which cannot be built into this product, but must be applied by the operator.
SAVE THESE INSRUCTIONS.
2/ IMPORTANT SAFETY CONSIDERATIONS
FAILURE TO FOLLOW THESE SAFETY PRECAUTIONS AND INSTRUCTIONS COULD RESULT IN DAMAGE TO THE PRODUCT AND/
OR SERIOUS INJURY TO YOU!
Make sure all moving parts are free from interference.
Keep hands clear of all moving parts.
Ensure workbench is used in a dry place, protected from rain. The product is for INDOOR use only. Do not store or use it outdoors
or in a moist environment.
Keep work area well lit.
Be aware of over balancing. When using this product in all modes, please keep your body or a heavy object in the centre or surface
to avoid overbalance. Incorrect usage may cause it to turn over and result in personal injury.
When transporting the workbench in a vehicle, always tie down to prevent movement and possible damage.
Check to make sure that all fixing screws and knobs are tight and all legs are locked into position before operating the workbench.
DON'T USE SCAFFOLD/PLATFORM MODE WITH LEGS FULLY EXTENDED. Always use this product on a stable, level surface. Failure
to use properly or overload may result in serious personal injury.
When using this product with power tools, please refer to the manufacturer's instructions for guidance on usage.
The product must be used only for its prescribed purpose. Any use other than those mentioned in these instructions will be
considered a case of misuse.
The manufacturer shall not be liable for any modifications made to the tool or for any damage resulting from such modifications.
3/ASSEMBLY
Your 7-in-1 workbench comes fully assembled, just take it out of the packaging and follow the simple set up steps, then it's ready
to use.
1- Workbench mode
4- Platform mode
The manufacturer shall not be liable for any damage or injury resulting from such cases of misuse.
2- Sawhorse mode
5- Car creeper & dolly mode
3- Scaffold mode
6- Hand truck mode
18