Heltun Quinto HE-RS01 Kurzanleitung Seite 12

DISASSEMBLY
1. ENSURE POWER IS SWITCHED OFF at the main circuit breaker AND THE LED INDICATOR
IS OFF.
2. Disconnect the wires by inserting a small Phillips-head screwdriver into the slot
beneath each wire and unscrewing to release.
Z-WAVE NETWORK
The HE-RS01 may be operated in any Z-Wave network with other Z-Wave certi ed devices
from other manufacturers. The HELTUN HE-RS01 will act as a 'repeater' for other devices
regardless of manufacturer or brand to increase the reliability of the overall network.
Security
S0, S2 unauthorized, and S2 authorized Inclusion Modes are supported. If you use the S2
authorized Inclusion Mode the security key should be used during the inclusion process. The
Security Key is printed on a card located with this quick start guide and also on the device
(see Figures 4 & 5).
Note: Be sure to save this key. Without the key, it is impossible to perform an Inclusion in S2
authorized mode.
SmartStart
SmartStart-enabled products can be added to a Z-Wave network by scanning the Z-Wave QR
Code shown on the product with gateways/controllers that provide for SmartStart inclusion.
In this case, no further action will be required and the SmartStart product will be added
automatically within ten minutes of being turned on in the vicinity of a network.
To add the HE-RS01 to the Z-Wave network using SmartStart:
1. Set the main controller in Security S2 Authenticated "Add Mode".
2. Input the Relay Switch 'Quinto' DSK to the controller's Node Provisioning List (or scan
the QR code).
3. Power on the device.
4. Wait for the adding process to complete.
5.
Successful adding will be con rmed by a message on the Z-Wave controller and the
LED indicator on HE-RS01 will turn green for three seconds then continue to slowly
blink green continuously while the device is Powered On.
Note: The device security code (DSK) and SmartStart QR code are printed on the rear and
front of the HE-RS01 plus on the additional Security Card included in the packaging (see
Figures 4 & 5).