AERMEC VMF-E2D Bedienungs- Und Installationsanleitung Seite 9

CONTENTS
Important information
Control panel functions
Use
Visualisations for the user
Installation information
Wiring diagrams
IMPORTANT INFORMATION
WA R N I N G : V M F - E 2 D a r e
designed for indoor use.
WARNING: the fan coil is con-
nected to power supply and
water circuit. Operations performed
by persons without the required
technical skills can lead to personal
injury to the operator or damage to
the unit and surrounding objects.
WARNING: components sensi-
tive to static electricity may be
destroyed by discharge notably
lower than those at the human per-
ception threshold. These discharges
form when you touch a component
or electric contact of a unit, without
first discharging accumulated static
electricity from your body. The
damage caused to the unit by an
overvoltage is not immediately evi-
dent - it only appears after a certain
period of operation.
STATIC ELECTRICITY ACCUMULATION
Any person not connected in a con-
ductive manner with the electronic
potential of his surrounding environ-
ment can accumulate electrostatic
charges.
STANDARD PROTECTION AGAINST
ELECTROSTATIC CHARGES
Earthing quality
When working with units sensi-
tive to electrostatic electricity,
ensure that people, workplaces and
unit casings are correctly earthed.
This will prevent the formation of
electrostatic charges.
Avoid direct contact
Only touch the element exposed to
electrostatic risk when absolutely
essential (e.g. for maintenance).
Touch the element without com-
ing into contact with either the
contact pins or the wire guides. If you
follow this rule, the energy of the
electrostatic charges cannot reach or
damage the sensitive parts.
Before taking measurements on the
unit, it is necessary to discharge
all electrostatic charges from your
body: to do this, just touch an
earthed metal object. Only use
earthed measuring instruments.
POWER THE FAN COIL ONLY WITH
230V, SINGLE-PHASE VOLTAGE
Any other type of power supply could
permanently damage the fan coil.
ADJUST TEMPERATURE ADEQUATELY
The room temperature should be
adjusted in order to provide maxi-
mum comfort to the people in the
room, especially if they are elderly,
children or sick people; avoid differ-
ences over 7°C between the outdoor
temperature and the temperature
inside the room in summer.
In summer, a temperature that is too
low causes higher electrical con-
sumption.
MALFUNCTIONING
In the event of a malfunction, cut
off power supply to the unit, then
restore the power and start the unit
again. If the problem occurs again,
call the local After-Sales Service
immediately.
DO NOT TUG THE ELECTRIC CABLE
It is very dangerous to pull, tread
on or crush the electric power
cable, or fix it with nails or drawing
pins.
A damaged power cable can cause
short circuits and injure people.
AVMFE2D 1504 - 6795755_01
9
10
11
12
13
33
9