First Time Installation; Wall Mounting - Sharp HT-SB107 Bedienungsanleitung

8
4. VOL +/- – Increase/decrease the
volume level.
5. / – Skip to previous/next track
in Bluetooth/USB mode.
6. – Play/pause/resume playback in
Bluetooth/USB mode.
7. – (MUTE) Mute or resume the
sound.
8. BASS +/- – Adjust bass level.
9. TRE +/- – Adjust treble level.
10. EQ – Select a preset sound mode.
RC OPERATIONS
The provided Remote Control allows the
unit to be operated from a distance.
• Even if the Remote Control is operated
within the eff ective range of 6m, remo-
te control operation may be impossible
if there are any obstacles between the
unit and the remote control.
• If the Remote Control is operated near
other products which generate infrared
rays, or if other remote control devices
using infra-red rays are used near the
unit, it may operate incorrectly. Conver-
sely, the other products may operate
incorrectly.
BATTERY INSTALLATION
1. Press and slide the back cover to
open the battery compartment of the
remote control.
2. Insert two AAA size batteries
(included). Make sure the (+) and (–)
ends of the batteries match the (+)
and (–) ends indicated in the battery
compartment.
3. Close the battery compartment cover.

First time installation

Placement and Mounting
A
A1
A: Normal Placement (A1 - Attach
the silicone feet to the bottom of the
soundbar.
Place Soundbar on leveled surface in
front of TV.)
B: Wall Mounting

Wall Mounting

NOTE:
– Installation must be carried out by
qualifi ed personnel only. Incorrect
assembly can result in severe personal
injury and property damage (if you
intend to install this product yourself,
you must check for installations such
as electrical wiring and plumbing that
may be buried inside the wall). It is the
installer's responsibility to verify that
the wall will safely support the total
load of the unit and wall brackets.
– Additional tools (not included) are
required for the installation.
– Do not overtighten screws.
– Keep this instruction manual for future
reference.
– Use an electronic stud fi nder to check
the wall type before drilling and
mounting.
B