Herunterladen Inhalt Inhalt Diese Seite drucken

Warranty - Gigahertz Solutions UBB27 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für UBB27:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Ultrabreitbandantenne UBB27 / Ultrabroadband Antenna UBB27
significant to note which technique was used
for each measurement.
"Rattling tone" for marking of un-pulsed
transmitters
 When using the HF59B in audio analysis
mode with the UBB27 attached (The switch
"Signalanteil" or "Signal" set to "Voll" or
"Full"), one will almost always hear a rat-
tling tone. This is because sources of un-
pulsed radiation are almost always present
in the very broad frequency range of the
UBB27. The loudness of it is proportionate
to the percentage of un-pulsed radiation in
the total signal received. The marking is
done with a frequency of 16 Hz (very low).
An audio sample can be down-loaded as a
MP3 file from our home page.
UBB27 is a perfect match to the Frequen-
cy Filter FF6E
 It is remotely power supplied by the filter
through the antenna input, the antenna can
be assembled to the filter at all times as in
the "Allpass" setting all its frequency range
is covered while switchable bandpass fil-
ters allow for an accurate assessment of
the most important radio services.
Limits for using the RF amplifier HV10
 Only the HF59B can supply enough Power
for the UBB27 plus the HV10.
 The external attenuator DG20_G3, may be
used with the UBB27 plus either HFE35B
or HF59B.
© Gigahertz Solutions GmbH, D-90579 Langenzenn
Accuracy
By itself, the UBB27 inaccuracy range of +/-
3 dB extends from approx. 85 MHz up to 3.3
GHz. The antenna continues to work beyond
that, but with increasing attenuation.
We state the total accuracy of our HF analyz-
ers for the complete assembly of analyzer
plus antenna in a far field under well defined
conditions. (An "average measurement" with
the complete assembly placed on a non-
conductive support). The measurement inac-
curacies for the complete assembly are the
following:
 HFE35C plus UBB27 is the same +/- 3 dB,
and
HF59B plus UBB27 increases moderately
to +/- 4.5 dB.
Below 85 MHz the tolerance level of the set-
up for the calibration becomes predominant
and limits the accuracy achievable for the
demonstration of the instrument. A simula-
tion, which demonstrated an excellent corre-
lation of actual measurement and simulated
signals in the frequency band above the low-
er limit, proves a very good linearity down to
27 MHz. Without verification we cannot guar-
antee the accuracy. Frequencies below 27
MHz are damped out by an internal, extreme-
ly steep, high pass filter
Revision 1.8 (Mai 2013)

Warranty

We provide a two-year warranty for factory
defects on this antenna.
questions
service
For
and
tact for North America:
www.slt.co
For other Countries contact your local
distributor or:
Gigahertz Solutions GmbH
Am Galgenberg 12
90579 Langenzenn, Germany
Phone ++49-(0)9101 9093-0, Fax -23
www.gigahertz-solutions.com
please con-
Seite 8

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis