Funke Gerber RD-8 Bedienungsanleitung

Funke-Dr.N.Gerber Labortechnik GmbH
Ringstraße 42 12105 Berlin
Reference Dryer
English
RD-8
Funke-Dr.N.Gerber Labortechnik GmbH
Ringstraße 42 12105 Berlin
Operating Instructions
The RD-8 was developed for the determining the remaining
moisture of Milk powder.
Principle: An examination sample is dried under flowing, dried
air. The mass loss of the examination sample is
determined and listed in mass percentage.
This method is described in the international standard
DIN/ISO 5537 or IDF 26.
The following parameters should be complied with precisely for
drying milkj powder in accordance with the standard above.
1. Temperature: 87 C
2. Airflow: 33 ml/min.
3. Drying time:
In addition, other powder-like samples ca be examined or dried.
1. Set up and commissioning
1.1. Setup and electical connection:
The device must be placed on a level, horizontal surface.
Place the device on a level surface. It is connected to a grounding
outlet (230V / 6A). The mains switch is located on the right front
side.
2
+ 1 C
+ 1ml/min.
5 h + 0,2 h