Behringer HEAVY DISTORTION HD300 Bedienungsanleitung

HEAVY DISTORTION HD300
Heavy Metal Distortion Effects Pedal
Thank you for showing your confidence in us by purchasing the
Behringer HEAVY DISTORTION HD300. This high-quality effects
pedal enables you to produce super thick, tube-like distortion plus
endless sustain. Thanks to its high-performance features you can
achieve the typical hard rock or heavy metal distortion sounds, when
playing over a clean amp channel.
1. Controls
The LEVEL control adjusts the output level.
(1)
The TONE control allows you to shape your overall sound.
(2)
The BOTTOM control allows you to boost/cut the low-frequency
(3)
range.
The DIST(ortion) control adjusts the amount of distortion.
(4)
The GAIN BOOST control adjusts the gain for more extreme
(5)
distortion sounds.
The ON/BATT LED illuminates when the effect is activated. It also
(6)
serves as a battery level indicator.
Use the footswitch to activate/deactivate the effect.
(7)
Use this ¼" TS IN connector to plug in the instrument cable.
(8)
The ¼" TS OUT connector sends the signal to your amp.
(9)
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover.
To install or replace the 9 V battery (not included), press the hinges with
a ballpoint pen and remove the pedal cover. Be careful not to scratch
the unit.
V1.0
(2)
(1)
(3)
(9)
(6)
(5)
(4)
(8)
(7)