Gas Auto Changer (Option); Connecting Co Gas Cylinders; Automatic Co Gas Supply Line Switching - Phcbi MCO-50AIC Bedienungsanleitung

GAS AUTO CHANGER (OPTION)

When the optional gas auto changer MCO-50GC is installed, two connecting ports for CO
and B are available. If two CO
when one of the CO
Connecting CO
1. Prepare two CO
MCO-010R to both of the CO
Notes:
ꞏ Use a liquefied CO
ꞏ When MCO-010R is not available, attach gas regulators rated at 25 MPa(G) (250 kgf/cm
psi(G)) for the primary side, and 0.25 MPa(G) (2.5 kgf/cm
2. Connect the connecting port A for CO
and the gas regulator for the CO
using the included gas tube.
3. onnect the connecting port B for CO
C
and the gas regulator of the CO
using the included gas tube.
Note: For connecting and removing the tube and
for connecting to the gas regulator MCO-010R,
refer to pages 19-20.
Note: If the CO
2
incubators from a single gas cylinder, a CO
formed in the gas regulator. The gas regulator safety
valve will operate, and it may make an explosive sound.
4. After connecting the gas tube, make sure that no gas is leaking (ex. by using a gas leak detection
spray).
5. For both CO
2
0.03MPa(G) –0.1 MPa(G) (0.3 kgf/cm
injecting.
Recommended pressure: 0.03 MPa (0.3 kgf/cm
Notes:
ꞏ As the pressure increases, the CO
cause gas supply lines inside the incubator to come loose, which may result in gas poisoning or oxygen
deprivation due to the escaping of gas. If gas lines come loose, the incubator must be repaired.
ꞏ Close the valve of the CO
Automatic CO
When an optional gas auto changer MCO-50GC is installed, CO
displayed in the home screen. The CO
CO gas supply line indicator A and B
2
gas cylinders are connected, the CO
2
gas cylinders becomes empty.
2
gas cylinders
2
gas cylinders (CO
2 2
gas cylinders.
2
gas cylinder (at least 99.5 % pure). The siphon (dip tube) type cannot be used.
2
2
gas cylinder A
2
2
gas cylinder B
2
gas is supplied to multiple CO
solid will be
2
gas cylinders A and B, adjust the secondary side pressure of the gas regulator to
2 (G) –1 kgf/cm
gas density control range will increase. Excessive pressure may
2
gas cylinder when the CO
2
gas supply line switching
2
gas supply line currently in use is highlighted.
2
gas cylinder A and B) and attach the optional gas regulators
2
(G), 36 psi(G)) for the secondary side.
gas pipe
Lower right side
gas pipe
2
2 (G), 4.4 psi(G) –14.5 psi(G)) while CO
2 (G), 4.4 psi(G)).
gas is not in use.
2
CO gas supply line which is used now)
(
2
<Right side of the display>
gas supply line can be switched
2
Connecting port B for CO
Connecting port A for CO
gas supply line indicator A and B is
2
gas pipes, A
2
2
(G), 3,600
gas pipe
2
gas pipe
2
gas is
2
67