UNI-T UT-203R Bedienungsanleitung Seite 8

Measuring capacitance
Note: Use the REL function to measure capacitance
lower than 100 nF.
1. Set the function
selector to
2. Connect
the black
test lead to
the negative
COM input
terminal and
the red test lead
to the positive
input terminal.
3. Connect the tips of both test leads to the circuit.
4. Read the displayed value. Press [ HOLD/
save the reading.
5. Disconnect the test leads.
Testing for continuity
Before measuring the continuity of a circuit, first
turn off the power.
1. Set the function
selector to
2. Connect
the black
test lead to
the negative
COM input
terminal and
the red test lead
to the positive
input terminal.
3. Connect the tips of both test leads to the circuit.
- If the measurement is <10 Ω the instrument
will emit a clear audible signal.
- If the measurement is >31 Ω the instrument
will emit no audible signal.
- If the measurement is between 10 and 31 Ω
the instrument will emit an irregular audible
signal.
4. Read the displayed value. Press [ HOLD/
save the reading.
5. Disconnect the test leads.
.
.
8
Capacitance
Continuity
Diode
Resistance
Red Black
] to
Capacitance
Continuity
Diode
Resistance
Red Black
] to