Cleaning And Maintenance - Trebs 99363 Bedienungsanleitung

backwards and the remaining water in the ice tray is drained back into the water reservoir. The ice
cubes are then dropped from the evaporator and pushed forward into the ice basket by the ice shovel.
The ice tray will automatically move back into position under the evaporator and start the next cycle.
9. The "ICE FULL" indicator will light up when the ice basket is full and then the ice cube maker will stop
the ice-making cycle automatically. Gently remove the ice from the ice basket with the ice scoop.
About 5 seconds later, the ice cube maker will restart its ice making function automatically.
10. The "ADD WATER" indicator will light up when the water reservoir is lack of water and the ice-making
cycle will stop automatically. At that time, remove the ice basket and add water to the water reservoir,
and then press the "ON/OFF" key again to restart the ice-making cycle. The appliance will start working
automatically after some time if the operator forgets to restart the appliance after refill.
11. When you have got your desired amount of ice, stop the ice making cycle by pressing the "ON/OFF"
key and unplug the unit from the wall outlet.
12. Open the top lid and transfer the ice to a freezer.
13. Allow the ice cube maker to reach room temperature.
14. We suggest replacing the water every week. Please empty the water reservoir if the ice cube maker is
not used for a long time.

CLEANING AND MAINTENANCE

To keep your ice fresh and your ice cube maker looking great, we recommend cleaning your ice cube
maker once per week.
1. Stop the ice-making cycle by pressing the "ON/OFF" key, unplug the ice cube maker from the wall
outlet and allow it to warm up to the room temperature.
2. If residual water is found in the ice tray, gently push the ice tray back so all water drains into the water
reservoir.
3. Move the appliance forward to a place 60mm away from the working table and open the drain plug
to drain out excess water (see Fig.3, Fig.4 and Fig.5).
4. Remove the ice basket.
5. Clean the ice cube maker interior with a soft cloth soaked with warm water and vinegar, then rinse
with clean water and then drain all the water.
6. Replace the drain plug well in position. Wash the ice basket and ice scoop in warm soapy water. Rinse
and dry.
7. Clean the exterior of the ice cube maker with a soft damp cloth. Use a mild dishwashing soap, if
necessary.
NOTE:
1) Do not use organic solvent, boiled water, detergent, strong acid and strong alkali etc. for cleaning.
2) Do not clean the evaporator.
8. Please empty the water reservoir and dry it for storage if the ice cube maker is not used for a long
time.