Troubleshooting - AmazonBasics B071VNCNLD Bedienungsanleitung

Cleaning the HEPA Filter
• Pull the tab on the right side of the exhaust grid
outwards and remove the grid.
• Pull the tab on top of the filter downwards and remove
the HEPA filter
• Rinse the filter under cold water.
• Dry it afterwards.
• Put the filter back in place and reinstall the exhaust grid.
NOTICE

Troubleshooting

Problem
The appliance does not start.
Weak suction power.
Motor is abnormally noisy.
12
8
.
Never use the appliance without filters installed. This can
cause power loss or damage to the appliance.
Solution
• Connect the power plug properly.
• Check if the electrical outlet is powered.
• Check if the on/off switch is on.
• Check if the flexible hose, extension tube or
any of the accessories are obstructed.
• Remove and clean the filters.
• Stop using the appliance immediately.
• Check if the hose, tube or any of the
accessories are obstructed.
• Remove the obstruction.
• If the noise continues, power off the appliance
and disconnect the power plug.
• Contact your service agents.
5