NASA WS500 Bedienungsanleitung Seite 11

3 - SETTING THE DATE AND TIME
- Press the (TIME) for 2 seconds to enter the date and time setting mode.
- The first data to be set is the time display format (12/24 Hr).
- Use the (UP) and (DOWN) buttons to adjust the values.
- Press the (TIME) button to confirm and then move to the next data setting whose display will flash.
- The setting order is as follows: hour → minute → year (Yr) → month (M) → day (D) → day of the
week display language (DAY: GE / FR / IT / DU / SP / DA / EN)
- At each setting, use the (UP) and (DOWN) buttons to adjust the values and press the (TIME) button
to confirm.
- If the buttons are not pressed within 10 seconds, the unit automatically exits the date and time set-
ting mode and saves the last selected values.
4 - SETTING THE ALARM
- Press the (AL) button twice to select one of the two alarms (AL1 or AL2) and then press this button
again for 2 seconds to set it.
- The first data to be set is the hour.
- Use the (UP) and (DOWN) buttons to adjust the values.
- Press the (TIME) button to confirm and then move to the minutes setting.
- If the buttons are not pressed within 10 seconds, the unit automatically exits the date and time
setting mode and saves the last selected values.
ACTIVATING / DEACTIVATING THE ALARM
- Press the (UP) button to activate or deactivate one of the two alarms. The symbol of the activated
alarm will then be shown on the screen.
NOTE: by pressing the (UP) button three times, it is possible to activate both alarms.
STOPPING THE ALARM
- The alarm is triggered at the programmed time and sounds as follows:
• 0-10 seconds: 1 BEEP per second
• 10-20 seconds: 2 BEEP per second
• 20-30 seconds: 4 BEEP per second
• beyond 30 seconds: continuous BIP
- To stop the alarm, press the (UP) button; it will sound again the next day at the same time.
SNOOZING THE ALARM (SNOOZE)
- When the alarm sounds, press the (SNZ) button if you want to delay it: the Z symbol flashes and
z
the alarm stops. The alarm will sound again after 5 minutes.
- Then press the (UP) button to deactivate the alarm snooze.
5 - BACKLIGHTING
- If the weather station is plug into a power source with the supplied USB cable, the screen backlight will
be constant.
- If it is powered by batteries, the screen backlight is turned off to save energy. It is necessary to press the
(SNZ) button to activate it for 5 seconds.
6 - CLEANING AND MAINTENANCE
- Before cleaning the unit, disconnect the power supply.
- Only clean the outside of the unit and use a dry cloth. Do not use cleaning fluids to avoid damaging
the electronics.