Herunterladen Inhalt Inhalt Diese Seite drucken

NASA WS500 Bedienungsanleitung Seite 10

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

INSTALLATION / USE
1 - INSTALLATION
WEATHER STATION
- Open the stand on the back of the weather station.
- Place it on a flat horizontal surface.
SENSOR
The sensor can be installed:
- either on the wall using a screw (not included). Hang the sensor through the hole on the back.
- or horizontally
To connect it to the weather station, proceed as follows:
- Press the (CH) button to select the transmission channel on which the slider within the batteries
compartment of the sensor has been placed.
- Press and hold the (CH) button for 2 seconds to start searching for the sensor signal. The corresponding
indicator will then flash on the display for 3 minutes to indicate that it is being detected.
- Once the connection is established, the indicator will stop flashing and the outdoor temperature
reading will appear on the display.
NOTE: if no signal can be detected, the weather station will automatically restart a search the next
hour. If it fails to detect the sensor signal after several attempts, press and hold the (CH) button
again for 2 seconds to reset the search. Also note that it is necessary to reconnect the sensor
each time the weather station is powered off.
For best results:
- Do not expose the sensor to direct sunlight or moisture.
- Do not place the sensor more than 10 metres away from the weather station.
- Minimise obstacles (doors, walls and furniture) between the sensor and the weather station.
- Keep the sensor away from metal or electronic objects.
2 - USE OF THE WEATHER STATION
WEATHER INDICATOR
When the unit is turned on, the weather station will show the weather conditions in the form of icons:
TEMPERATURES AND HUMIDITY
The weather station displays the following information:
- Indoor temperature (3) and humidity (5) measured by the weather station
- Outdoor temperature (7) from the sensor
NOTE: this data is updated every 30 seconds except when the alarm sounds.
CHOICE OF TEMPERATURE UNIT
- Press (DOWN) button to select the temperature unit: °C (Celsius) or °F (Fahrenheit).

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis