Finishing An Edge With A Radius Scraper; Trimming With A Chamfer Bit; Maintenance And Control; Maintenance After Work - IGM Professional 142-PD80 Bedienungsanleitung

7.3 Finishing an edge with a Radius Scraper

For finishing an edge – cut off the excess edge
after trimming. Pull out the Radius Scraper by
tipping and then pulling it out (fig.13) and (fig.14).
Grab the scraper with both hands for better
support when trimming edges (fig.15).
fig. 13

7.4 Trimming with a chamfer bit

The radial router bit can be exchanged for a chamfer
bit. Set the depth of trimming according to previous
steps. – maximum depth 2mm and maximum stroke
6 mm.

8. MAINTENANCE AND CONTROL

Before attempting to inspect or maintain the
trimer, always make sure it is turned off and
unplugged

8.1 Maintenance after work

After work, clean the machine from impurities.
Especially make sure that the motor vents are not
clogged up. To unplug the vents, use a brush with
soft bristles or compressed air.
Carbon brush replacement
If the machine excessively sparkles and is losing
performance a carbon brush replacement is needed.
To maintain SAFETY and RELIABILITY of the
product, all repairs and any other maintenance must
be carried out by an authorized IGM service center
and with the use of original spare parts.
www.igmtools.com
fig. 14
fig. 15
Operating manual EN

9. MALFUNCTION ASSISTANCE

The Motor does not start
* There is no power – check power supply and fuse
* Motor, switch, cable failure – contact the supplier
* Worn carbon brushes – see carbon brush
replacement
Excessive vibrations
*Router bit is badly affixed – Reaffix it again
The cut is not clean
*Blunt instrument – use a sharper bit

10. ENVIRONMENTAL PROTECTION

Protect the environment. Your device contains
recyclable materials. Please leave it to specialized
institutions.
11. OPTIONAL ACCESSSORIES
Collet 8mm
code: 142-PD80-080
IGM End trimmer for shaped and straight panels
code: M951
IGM Vacuum Clamp One-sided
code: M964
7