Assembly Of The Feeder; Electrical Connection - IGM Professional AF32 Bedienungsanleitung

Mounting hole pattern / Montage Lochbild / Image de montage
JPF-1, JPF-2....Light duty (hole pattern 63x63mm, M10)
JPF-3....Light-Heavy duty (hole pattern 90x108mm, M12)
JPF- 34/ 48....Heavy duty (hole pattern 90x108mm, M12)
pic.3
1. Unpack the feeder base and adjust it according to
the mounting template.
2. Prepare 4 bolts and spring washers (not included).
Bolt size - M12, length = feeder base (thickness) +
table top (thickness)
3. Select position of the base to avoid ribbing on the
bottom of the table.
4. Place the template on the table, use a tape to hold
two sides of the template
5. Use something to mark out the holes and drill
them out.
B.1) Fastening with a nut through the table
1. Insert the screws with washers through the base
and the tabletop.
2. Tighten the nut to the table.
B.2) Fastening with a thread in the table
1. Use a screw cutter to drill out the holes.
2. Insert the screws with washers through the base
and screw it them into the tabletop.

5.2.2 Assembly of the feeder

- Place the stand (5) into the base (1) fastened to the
table
- Mount the height adjustable holder (3) with the jib
onto the stand (5).
- Assemble adjustment levers (6) and (13).
- Attach the foot of the stand through which you will
put the screw of the lever (6).
- Screw in the lever screw (6) into the height-
adjustable holder (3).
- Insert the feeder arm (8) into the height-adjustable
holder (3). Attach the lever (13).
Rotate the lever (13) a couple of times. Tighten the
lever (7.)
- Attach the end joint (16) to the feeder arm (8). WE
RECOMMEND: Thoroughly grease up connecting
www.igmtools.com
www.igmtools.com
ŠROUB M12
ŠROUB M10
POKUD JSI NEJSTE JISTI ROMĚRY
ZÁKLADNY
!POZOR! - zkontrolujte si měřítko zda
opravdu odpovídá
LEHKÝ PROVOZ
LEHKÝ-TĚŽKÝ PROVOZ
TĚŽKÝ PROVOZ
pic.4
10
12
16
9
15
17
14
surfaces during assembly. Gently tighten the screw (9).
- Screw a joint onto the feeder (15) and tighten the
locking lever (11).
- Slide the arm with the end joint (16) down to the pin
of the joint (15) and screw it in with a lever (10).
- Properly tighten all screws and levers.

5.3 Electrical connection

WARNING: Make sure the electrical connection
corresponds to the motor specification (see engine
cover.) WARNING: Make sure the switch is in the
„OFF" position.
A) Integrated power supply:
A power feeder is an auxiliary machine that
cooperates with your spindle moulder, table saw or
a planer.
It is necessary that the machine is connected in
accordance with valid directives.
The electrical connection to your machine using the
integrated power supply is controlled by the main
switch and an emergency stop meaning you have full
control over the machine. In addition, the integrated
power supply provides protection against overload of
the machine.
Current-carrying capacity
Tyoe 32
Current 1,5A
The integrated power supply can be installed only
by a qualified electrician.
B) Separate power supply:
You should use a separate electric socket with copper
Operating EN
6
7
8
3
4
11
5
2
1
13
5