Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ESC910
LED display
Error indicator
Battery-level indicator
Description of push buttons/features
1. Power Push Button: press and hold the Power Push Button to turn the power on/off
2. Thumb Throttle: press the Thumb Throttle to start and accelerate
3. Brake: squeeze and hold the Brake Lever to work the Disc Brake. Press the Rear Fender slightly to
assist the braking (during braking the rear LED lamp flashes)
4. Function key: press the Function Key to select the speed mode
a. Beginner mode: "D" not displayed
b. Normal mode: "D" lights up white
c. Sports mode: "D" lights up red
5. LED lighting: press the Function Key twice to turn on the front and rear LED lights on; press the
Function Key twice again to turn the LED lights off.
6. Cruise-Control Mode: maintain your current speed for approximately 6 seconds to enter the
Cruise-Control Mode; press the Thumb Throttle or squeeze the Brake Lever to deactivate the
Cruise Control.
7. Warning light Indicates that the controller temperature is too high. As soon as it appears on the
display, stop riding immediately, switch off the scooter, and wait until the controller cools down.
Using the scooter with the light on can cause permanent damage to the controller. This fault is not
covered by the warranty.
Unpacking
After opening the cardboard box, first remove the scooter and make sure that all parts are complete.
If anything is missing, contact your dealer. Check the condition of the unit and its appearance to
ensure that the folding system is stable enough and that the platform is free from cracks. Check also
that the display screen is not damaged.
Installation
After unpacking and checking the condition of all components, you can start assembling the
scooter. Follow the picture below:
1. Assembly after removal from the packing.
A
B
6
Actual speed
Warning light
Speed mode
Speed unit
C
D
Werbung
