Operation Requirements - Laserworld Club Serie Bedienungsanleitung

CS-250 RGY, CS-500 RGY, CS-400 RGB, CS-500 RGBV
Keep away from heaters and other heat sources. In order to safeguard sufficient ventilation, leave
50 cm of free space around the device.
Never direct the laser beam to people or animals.
CAUTION LASER DIODE: If you open the device for cleaning, always disconnect from mains!
-HEALTH HAZARD! Never look directly into the light source, as sensitive persons
may suffer an epileptic shock!
These lasers are considered a definite eye hazard, particularly at the higher power levels, which
WILL cause eye damage. Warning labels and aperture labels are affixed to the laser.
Installation safety
Prior to installation and operation of the laser, the paths of the beams and effects should be
considered, particularly with respect to how they will reach the audience. If direct audience
scanning is desired, then the laser energy in the effects needs to be considered to decide if the
effects are safe for direct viewing. Always ensure that the maximum permissible exposure (MPE) is
not exceeded in the area accessible to the public. So install the laser in such a way, that minimum
distances and heights ensure that the MPE is never exceeded in the public area.
Warning labels on the device
Laser radiation
Avoid exposure
To the beam
Laser class 3b
Caution of radiation
If cover is removed
Only use indoors
At front opening:

Operation requirements

The operator has to make sure that laser radiation – also reflected laser radiation – higher than the
maximum permissible level is avoided by technical or organisational measures
Make sure to use the correct voltage. Always use a grounded mains connection. Don't use a remote
controlled or other electronically switched main connection. Don't use together with large
appliances (especially fog machines/hazers) on the same mains.
If the device is used in a flying installation, the mounting brackets and an appropriate safety-rope
must be fixed.
In some countries, the operator must notify the accidence insurance and the authority for industrial
safety, before operating a laser. For more information, contact the relevant authorities.
Please consider that unauthorized modifications on the device are strictly forbidden due to safety
reasons!
If this device will be operated in any way differently than described in this manual, the product may
suffer damages and the guarantee becomes void. Furthermore, any other operation may lead to
dangers like short-circuit, burns, electric shock, etc.
Keep surrounding dry and clean.
dusty environment, don't place liquid filled receptacles on the device. Projector should be put in a
water-proof housing when operated outside.
Regularly open the device (see "cleaning" further down) to check for dust inside, or if fog fluid
condenses in the housing (if so rearrange hazer and/or laser position).
Operating temperature is 10~35° C . In a new installation, check after some 15-30 minutes whether
the outlet air gets too warm. Regularly check the inside for dust deposits, especially around the
fans. Let laser cool off 10 minutes after 2 hours of operation, to ensure maximum lifetime for the
diode. Be careful not to direct stage lights toward the laser (especially moving heads), this can
cause overheating.
Distance between laser aperture and projection screen should be not less than 1 meter.
Avoid exposure – laser radiation is emmited.
This unit should be keep dry, do not use in the rain or damp and
Read manual
before use
Operation by qualified
personal only
Never direct laser
Beam at people
Never look directly
into beam
Rev: Mar-10
3 / 18