Please note that the empty TrayCell has an absorbance of around 1.
To correct this characteristic absorbance, first carry out a reference
measurement with the solvent in which the sample was dissolved.
You can then start taking measurements with the sample.
Please note that the cap must be correctly positioned on the TrayCell
before you start measuring!
If necessary, the sample can be recovered by pipetting once the
measurements are complete.
Finally, clean the window and the mirror inside the cap.
A
Pipette sample onto window.
C
Remove cap and recover
sample if necessary.
B
Position cap.
Start measurement.
D
Clean window and cap
(TrayCell remains in
spectrophotometer).
Attention: Place the cap in
such a way that the pins are
in the notches of the cap.
E
Pipette new sample
onto window.