Miele professional PG 8090 Gebrauchsanweisung Seite 13

Before use
^ Find out the mains water hardness
level in your area before using the
Monoblock water softener for the first
time.
The Miele authorised service technician
will require this information in order to
set the correct reactivation interval for
the water hardness level.
^ Please make a note of the water
hardness level here.
Hardness level:
When installing the Monoblock water
softener the Miele authorised service
technician will connect the appliance to
the water inlet and outlet points, fill the
resin cartridge with water and start the
Monoblock system.
The built-in salt valve limits the amount
of water going into and out of the unit
by means of a float switch to ensure
there is sufficient salt available for
reactivation.
Only use reactivation salt that is suit-
able for water softeners.
It is important to use a good quality re-
activation salt. Only use salt tablets or
coarse grained reactivation salt (8-15
mm grain).
Never use cooking salt as it contains
particles which do not dissolve in water.
These particles can cause a blockage
in the Monoblock system.
Filling the salt container
^ Remove the lid.
^ Fill the salt container with reactivation
salt or salt tablets via the salt filler in-
let.
Capacity: 10 kg
First fill: 10 kg
Do not let any salt get into the salt
valve tube.
The salt valve is protected by a
cover. Make sure that this is closed.
^ Close the lid.
To keep evaporation to a minimum
make sure that the lid is always
replaced securely in position.
The Monoblock water softener is now
ready for operation and will deliver
softened water.
Please contact the Miele Service
Department if you have any
concerns.
Operation
13