SVBONY SV606 Bedienungsanleitung Seite 10

2.5.2 Turn on the device
Click the "Device" option in the upper left corner, then click
"Open". There will be a device selection popup. Select the
device you want to use and then click the "Open" option below
to open the device.
You can use the "Snap a image" / "Capture a video" / "Measure
function" function to operate the software to observe and mark
the specimen.
When using measurement mode, the microscope must be
calibrated before accurate measurement
PC version camera mode software (only camera function)
1.The installation file can be installed using the CD or
downloaded from the official website of SVBONY.
1.SVBONY official download address：
https://www.svbony.com/Support/SoftWare-Driver/ Enter the
address from the browser to download and install
2. CD installation:
2.1 Put the CD into the CD-ROM, and the files of the CD will be
automatically displayed on the screen.
Note: If the CD-ROM does not run automatically, please
double-click "CD-ROM", or right-click "open" under the
CD-ROM menu bar
8