Troubleshooting - Peiying PY-4C127 Bedienungsanleitung

TROUBLESHOOTING

Before removing your amplifier, refer to the list below and follow the suggested procedures.
Always test the speakers and their wires first.
AMPLIFIER WILL NOT POWER UP.
• Check for good ground connection.
• Check that remote DC terminal has at least 10V DC.
• Check that there is battery power on the + terminal.
• Check all FUSES.
• Check that Protection LED is not lit. If it is lit, shut off amplifier briefly and then repower it.
PROTECTION LED COMES ON WHEN THE AMPLIFIER IS POWERED UP.
• Check for shorts on speaker leads.
• Check that volume control on the head unit is turned down low.
• Remove speaker leads, and reset the amplifier. If the Protection LED still comes on, then the
amplifier is faulty.
• The amplifier will shut down automatically when the units' temperature goes up to 85°C, this will
protect the units from damage.
AMPLIFIER'S GETS VERY HOT.
• Check that the minimum speaker impedance for that model is correct.
• Check for speaker shorts.
• Check that there is good airflow around the amplifier. In some applications, an external cooling
fan may be required.
DISTORTED SOUND.
• Check that the level control's is set to match the signal level of the head unit.
• Check that all crossover frequencies have been properly set.
• Check for shorts on the speaker leads.
HIGH SQUEAL NOISE FROM SPEAKERS.
• This is always caused by a poorly grounded RCA patch cord.
WARNING
1. Over high volume will damage your speakers.
2. Be cautious when you use the amplifier near gasoline tank and electric wires.
3. Protect the connecting wires and parts to avoid any damage or short circuit.
4. The power must belee from the anode of the battery via FUSE.
5. Be sure that you use the same type of FUSE when you need to replace it.
Specifications are subject to change without notice.
Owner's manual
EN
13