Electrical Connection; Specification - Peiying PY-4C127 Bedienungsanleitung

SPEAKER
8
Speaker connecting terminals.
FUSE
9
Standard automatic fuse, you must use the same power fuse if you need to change it.
+12V
10
Anode of power connection terminals. Connect to the anode of car battery.
REM
Terminal to be connected with remote cable, which comes from the source and which con-
trols the amplifier switching on. Applied voltage must be between 10 and 15 VDC.
GND
Ground terminal. Connect to the car chassis. Keep the length of the ground cable to a mini-
mum.

ELECTRICAL CONNECTION

Connect to chassis
ground of vehicle.

SPECIFICATION

RMS power @ 14.4V DC
Power @ 4ohms
Power @ 2ohms
Bridged Power @ 4ohms
Minimum speaker impedance
EN
THD distortion
Frequency response
Input sensitivity
Input impedance
Signal to noise ratio
Channel separation
10
Owner's manual
+12V REM GND
Connect to +12v of battery with
appropriate fuse VALUE.
80W x4
120W x4
200W x2
2ohm
0.01%
20Hz ~ 20KHz
0.2V ~ 6V
10K
98dB
50dB
Connect to remote turn-on lead of
source unit.