Centrosolar PowerStocc 1200/2000 Installationshandbuch Seite 13

2. Installation and Setup
Specification
Fuse
2
Table 2.3: Recommended fuses
An automatic test of the inverter can be initialised by using the Inverter Autotest Software. Please
read the Autotest manual before initialising the software. Software and manual are available free
of charge, please contact your supplier for further information. The software is used in conjunction
with an RS485 to USB converter in order to communicate between inverter and PC. Such a con-
verter can be purchased at any retailer of computer equipment.
Note:
This is an international inverter. The inverter is approved and certified to run in 16 countries.
The inverter has not had country settings specified. It will not run before this has been done.
Check that all connections have the correct polarity and that cables are securely fastened. Turn
on the AC grid. The display will now prompt for "Language".
Illustration 2.10: Language
Illustration 2.11: Country
The inverter will start automatically if sufficient solar radiation is available. The start-up will take
a few minutes. During this period, the inverter will carry out a self-test.
12
PowerStocc
1200 / 2000
Current
Voltage
The inverter only complies with local and national standards provided the correct
country has been selected. If a different country than the one the inverter is installed
in is chosen it can have serious consequences.
PowerStocc
3000 / 4000
16A 16A
240V 240V
Press ' ' to scroll down through the languag-
▼
es. Select language by pressing 'OK'. The dis-
play will now show "Country" in the language
chosen previously.
Press ' ' to scroll down through the list of
▼
countries. Select the country in which the in-
verter is installed by pressing 'OK'. Confirm
selection by pressing 'OK'
The settings for the selected country has now
been activated, and the inverter is ready to
energise the AC grid.
L00410289-03_3m
PowerStocc
5000 / 6000
25A
240V