Walter WWS-IGS1000 Bedienungsanleitung Seite 76

Maintenance, cleaning, storage and transport
Cleaning and replacing the spark plug
NOTICE!
Remove the spark plug only if dust or dirt can not get into the spark plug
opening.
• Place the generator on a flat surface.
• Unscrew the butterfly bolt
open the side housing cover.
• Remove the spark plug connector
12
with a slight upward turning
motion.
• Blow the power generator,
especially the area of the spark
plug, using compressed to remove
dust and dirt.
• Turn the spark plug counter-clockwise using the spark plug spanner
• Check the condition of the spark plug:
− If there is a lot of carbon deposit on the contacts, get in touch with a
technician or the manufacturer's service address mentioned on the
warranty card.
− In case of light deposits, clean the contacts carefully with a copper wire
brush.
− If necessary, replace the spark plug with a spark plug of the same type
(see chapter "Maintenance" and "Technical data").
− The distance between the
electrodes should be 0.6 - 0.7 mm.
Adjust them with a screwdriver if
necessary.
76
640062_Buch_DE_EN_FR_CZ_SI.indb 76 640062_Buch_DE_EN_FR_CZ_SI.indb 76
9
by hand and remove the motor cover
8
10
12
7
0.6 - 0.7 mm
, to
.
07.01.2021 11:15:50 07.01.2021 11:15:50