Charger Location - Deuba monzana MZBC04 Bedienungsanleitung

CHARGER LOCATION

-
Locate charger as far away from battery as DC cables permit.

Never place charger directly above battery being charged; gases from battery will

corrode and damage the charger.
Never allow battery acid to drip on charger.

Do not operate charger in a closed-in area, or in any way restrict ventilation.

Do not set a battery on top of charger.

DC CONNECTION PRECAUTIONS
-
Connect and disconnect DC output clips only after removing AC cord from electric

outlet.
Never allow the clips to touch each other.

Attach clips to battery posts and twist or rock back and forth several times to make a

good connection. This tends to keep the clips from slipping off terminals and helps to
reduce risk of sparking.
FOLLOW THESE STEPS WHEN BATTERY IS INSTALLED IN A VEHICLE. A SPARK
-
NEAR BATTERY MAY CAUSE BATTERY EXPLOSION. TO REDUCE RISK OF A SPARK
NEAR BATTERY:
Position AC and DC cords to reduce risk of damage by hood, door, or moving engine

part.
Stay clear of fan blades, belts, pulleys, and other parts that can cause injury to persons.

Check polarity of battery posts. POSITIVE (POS, P, +) battery post usually has larger

diameter than NEGATIVE (NEG, N, -) post.
Determine which post of battery is grounded (connected) to the chassis. If negative post

is grounded to chassis (as in most vehicles), see item "e". If positive post is grounded to
the chassis, see item "f".
For negative-grounded vehicle, connect POSITIVE (RED) clip from battery charger to

POSITIVE (POS, P, +) ungrounded post of battery.
Connect NEGATIVE (BLACK) clip to vehicle chassis or engine block away from battery.

Do not connect clip to carburetor, fuel lines, or sheet metal body parts. Connect to a
heavy gage metal part of the frame or engine block.
For positive-grounded vehicle, connect NEGATIVE (BLACK) clip from battery charger to

NEGATIVE (NEG, N, -) ungrounded post of battery. Connect POSITIVE (RED) clip to
vehicle chassis or engine block away from battery. Do not connect clip to carburetor,
fuel lines, or sheet-metal body parts. Connect to a heavy gage metal part of the frame
or engine block.
When disconnecting the charger, disconnect AC cord, remove the clip from vehicle

chassis, and then remove the clip from battery terminal.
FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE VEHICLE. A SPARK NEAR THE
-
BATTERY MAY CAUSE BATTERY EXPLOSION. TO REDUCE RISK OF A SPARK NEAR
16 www.DEUBAXXL.de