Switching The Pump On; During Operation - NOVARDEN NSH35s Installations- Und Benutzerhandbuch

Heat pump installation

Switching the pump on

After completing and checking the power cable installation, switch
the heat pump on. To use the appliance correctly, you must comply
with the following:
• Open the swimming pool pump, then open the heat pump
• Close the heat pump, then close the swimming pool pump.

During operation

It is normal to see condensate draining from the bottom of the
appliance. This is from the condensation from the water vapour in
the air when it goes into the exchanger. You must make sure water
can easily flow from of the pump.
11
EN