ICAN 30-300 Gebrauchsanweisung Seite 41

30-300/ 500 JULI 02 REV. 01. (GB)
FITTING OF ICAN FILTERS (GB) 4
When fitting ICAN filters, two identical filters, suitable for the purpose for which
they are to be used, should be fitted before entering the polluted area. When
replacing filters, both ICAN filters must be replaced at the same time.
1.
At the bottom of the ICAN filter, a
"marking" can be seen. Hold the filter
such that the index finger is located
opposite the "marking".
2.
Guide the bottom of the ICAN filter
down onto the filter holder. When the
index finger/"marking" is in line with the
"arrow" on the front part of the half
mask, then the filter socket and filter
holder are in the correct position.
3.
Turn the ICAN filter in the direction of
the arrow until it cannot be turned
further. The filter is then correctly
fitted. The same procedure should be
followed when fitting the second filter.
 copyright 2002