What To Do If Someone Else Needs Help In The Water; Inflating By Mouth; How Do I Make Restube Ready For Its Next Use - Restube automatic Gebrauchsanweisung

2.4 What to do if someone else needs help in the water?

WARNING
Notify professional assistance and third parties first. Do not endanger your own safety!
Restube is not intended for towing people.
• Use the RESTUBE buoy as a buoyancy aid when approaching the person in need
• The RESTUBE buoy can be transferred to the person in need if the situation requires this
and both the necessary knowledge and physical condition exist
• Subsequently, further measures may be taken to assist the person

2.5 Inflating by mouth

WARNING
Never inflate the flotation device by mouth and trigger the CO2 cartridge afterwards. This may cause
over-inflation and serious damage. Never fill buoy with other gases! Do not fill buoy with the help
of an inflation device (e.g., pneumatic pump)! Please avoid inhaling the CO2 gas from the flotation
device when topping up the buoy via the oral valve
• Remove buoy from pocket
• Open the Velcro on the safety leash and unwrap safety leash
• U nfold buoy completely
• O pen the cap of the oral valve
• Inflate buoy with your breath using the valve

2.6 How do I make Restube ready for its next use?

Once Restube has been triggered, it must be made ready to be used again. You will need an original
RESTUBE-CO2-Cartridge.
NOTICE
Only the original RESTUBE-CO2-Cartridges are 100% quality-certified, seawater resistant and the
force is tailored to the RESTUBE trigger!
Do not use comparable commercial CO2 cartridges!
These will not guarantee inflation of Restube in an emergency.
The CO2 cartridge (#1)
Restube only guarantees functionality when using the original
RESTUBE-CO2-Cartridge (16g).
• Remove any dirt (e.g. sand).
• Remove protective cover from the CO2 cartridge.
• Unscrew the empty CO2 cartridge and dispose of with
residual waste.
• Fold away release lever to avoid piercing the new
CO2 cartridge.
• Place the new green securing clip on the red indenta-
tion on the trigger mechanism.
• Screw the new original-RESTUBE-CO² cartridge tightly
and up to marking into the trigger mechanism.
18
#1
#