Orca 050 CL Betriebs- Und Wartungsanleitungen Seite 23

c. Lower the unit into the water as shown in the left figure by draining it COMPLETELY FROM THE
EMPRISED AIR and ensure that the pool cleaner is correctly positioned on its wheels.
d. To remove the pool cleaner from the pool, pull it by the floating handle and its cord to the surface
of the water, then pull it out by the main handle.
e. To avoid damaging the pool wall or the pool cleaner, make sure that the pool cleaner does not
touch it while you remove it from the pool.
f. Before removing the pool cleaner from the pool, it is best to hang it 10 - 15 seconds above the
pool to drain it of water.
g. Turn off the pool cleaner after each use
fast start-up
2.2
Install the floating handle.
a.
Adjust the length of the supplied cord
according to the depth of the pool.
Connect the floating handle to the
pool cleaner at the point indicated in
the figure on the right.
b. Install the swivel plate on the top
cover, at the location indicated in
the right figure.
22