Specification; Operation; Learn More - Rebel LUT0069 Bedienungsanleitung

PRODUCT
Button description
1. °C / °F – temperature unit button
2. UP - pressing increases the set temperature by 1°C
3. DOWN - pressing decreases the set temperature by 1°C
4. Power button for desoldering gun.
5. Soldering station power button (on the back of the device)
Display description
• the display shows two temperature values - the lower one with the word SET
indicates the currently set temperature; the upper one with the word TEMP
indicates the current temperature of the soldering tip / air flow
• HEAT ON is displayed when the current temperature of the tip or the blown air is
lower than the set temperature
• WAIT is displayed when the difference between the tip / blown air and the
current temperature difference is higher than 10°C. This means that the
temperature control system is unstable and you should wait until WAIT
disappears before continuing.
• In case of incorrect operation, e.g. a damaged temperature sensor or when the
power cable of the soldering tip is disconnected from the soldering iron, the
display will show ERROR and a sound signal will be displayed.

OPERATION

1. Place the soldering station on stable, flat ground
2. Plug the soldering station into a power outlet and switch it on using the power
button on the back of the station.
Desoldering
1. The desoldering gun should be placed on a stand and connected to the central
unit using power cable.
2.The second input is for air suction - attached adapter should be screwed on the
protruding thread and the second cable for the desoldering gun should be put
on it.
3.Use buttons to set temperature.
4.During operation, the tip must not be clogged with the material sucked in. If this
happens, clean the hot desoldering tip with a brush.
5.When the desoldering is over:
• turn the station off with the station power button and wait for the desoldering
iron to cool down
• unlock the button on the back of the device
• remove the protection of the glass tube in which the material sucked in during
desoldering is located
• remove and empty the glass tube
• put the glass tube, filter and protection on the desoldering gun.
Note: The device can also be used as a soldering iron.
EN 6

SPECIFICATION

Central unit
Power supply AC 220-240V, 50 Hz
Fuse 3.15 A
Desoldering gun
Vacuum pressure 600 mmHg
Power consumption 60 W
Temperature range 160 – 480°C
Heating element Ceramic
Desoldering gun with a tip attached, two spare desoldering
tips, spare filters, 3 cleaners for different tip thicknesses,
In set
adapter for connecting the station with the desoldering
gun, holder for the desoldering gun, power cord

LEARN MORE

For more information on this device visit: www.rebelelectro.com.
Read owner's manual carefully before using your device.
Visit www.rebelelectro.com website for more products and accessories.
English
Correct Disposal of This Product
(Waste Electrical & Electronic Equipment
(Applicable in the European Union and other European countries with separate collection systems) This marking
shown on the product or its literature, indicates that it should not be disposed with other household wastes at the
end of its working life. To prevent possible harm to the environment or human health from uncontrolled waste
disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable
reuse of material resources. Household users should contact either the retailer where they purchased this product,
or their local government office, for details of where and how they can take this item for environmentally safe
recycling. Business users should contact their supplier and check the terms and conditions of the purchase
contract. This product should not be mixed with other commercial wastes for disposal.
Made in China for LECHPOL ELECTRONICS Sp. z o.o. Sp.k., ul. Garwolińska 1, 08-400 Miętne.
7 EN