Storing Accessories - Xiaomi MJWXCQ03DY Benutzerhandbuch

Turning On/Off & Vacuuming
Press and hold the on/off bu on
working and it runs on the standard mode by default. You can switch the mode as
needed.
Hold the handle of the vacuum cleaner by pushing it back and forth to vacuum
and clean the floor with the floor brush. You can also use the long nozzle or flat
nozzle according to your needs.
Press the on/off bu on again to stop the vacuum cleaner.
On/Off Bu on
for 1 second, then the vacuum cleaner starts
9
When the Vacuum Cleaner is Working
When the ba ery level is low, the ba ery level indicator will blink red, please
recharge the vacuum cleaner soon. If the vacuum cleaner runs on the standard
mode, it cannot be switched to the turbo mode.
If it is not recharged in time, the ba ery voltage will get too low, then the vacuum
cleaner will automatically turn off to protect the ba ery.
If the vacuum cleaner turns off due to running out of the ba ery, please recharge
it in a timely manner. Otherwise, the ba ery may damage because of its
over-discharging if it is not used for an extended period of time.
Notes
There is a small amount of ba ery in the vacuum cleaner when you get it. It is
recommended to connect the power adapter to fully charge the vacuum cleaner
before its first use.
When charging, the vacuum cleaner cannot be used.

Storing Accessories

The accessories can be stored on the wall mount when not in use. Vertically insert
the long nozzle or flat nozzle into the wall mount until you hear a click, with the
release bu on as the direction shown in the figure. To remove the accessories from
the wall mount, press the release bu on and simultaneously pull them down
vertically.
Release Bu on
Wall Mount
10