Lighting Instructions - Napoleon ROGUE RB425 Bedienungsanleitung

8

Lighting Instructions

EN
!
WARNING!
WARNING!
gas supply valve.
2. Push and turn any main burner
knob slowly to the high position. If
the pilot lights, continue to push
down on the control knob until the
burner lights and then release.
3. If the pilot does not ignite, then
immediately turn the control knob
back to the 'off position and repeat
4. If the pilot and burner will not
ignite within 5 seconds, turn the
control knob to the 'off' position
and wait 5 minutes for any excess
gas to dissipate. Either repeat steps
2 and 3 or light with a match.
match, clip the match into the
supplied lighting rod. Hold the
lit match down through the grill
and sear plate while turning the
corresponding burner valve to high.
!
NOTE!
www.napoleon.com
Side
Burner
Igniter
Open lid
Ensure all burner controls are in the off position. Slowly turn on the
Main Burner
Lighting
1. open grill lid
step 2 several times.
5. If lighting the unit with a
Do not use rear burner while operating main burner.
Left
Centre
Right
Burner
Burner
Burner
Rear Burner Lighting
(if equipped)
1. open grill lid
2. Remove warming rack.
3. Turn rear burner control to high
position.
4. Press and hold
igniter button until burner lights, or
light by match.
5. If ignition is not immediate, turn
burner control off. Wait 5 minutes.
Repeat.
Rear
Burner
Off Position
Side Burner Lighting
(optional)
1. open burner cover.
2. Turn side burner control to high
position.
3. Press and hold
igniter button until burner lights, or
light by match.
4. If ignition is not
immediate, turn burner control off.
Wait 5 minutes. Repeat.
N415-0664CE-GB-DE Nov 23.20