Functions - Gewiss Chorus GW 90 770 Anleitung

The wind sensor interface (GW 90770) allows you to connect the wind sensor (GW 90769)
to the movement control system for awnings, blinds etc.
The wind control system can, for instance, raise the blinds or awnings according to the
wind speed to protect the more fragile parts such as the blind laths from being damaged.
The wind sensor interface is fitted with two N.O. free of potential output contacts which
close when the set wind speed is exceeded.
The outputs can be connected to a contact interface (for instance GW90834 or GW90721)
to send the wind alarm signal to the KNX/EIB bus.
Output contacts
Note: the terminals marked 1 and 2 are not connected to the device and should not be
used.

FUNCTIONS

L
N
10
230Vac