H+H BS 21 Bedienungsanleitung Seite 10

Important! Jars and bottles are usually hotter than the contents when warmed up. You
should therefore always check the temperature of the contents before giving your child
the bottle. If the milk is too hot, allow the bottles to stand a few minutes.
3. ROTARY SWITCH
The rotary controller is continuously adjustable as follows to warm up milk bottles and food jars:
OFF
Note: the information provided serves as a guideline only. The actual temperature
always depends on the volume and type of food to be warmed up.
WARMING UP BOT TLES AND FOOD JARS
4.
see figure 1-5
6. Set the required warm up time by means of the rotary controller. The operating light
lights up, indicating switch-on.
7. When warm up time is over, the operating light goes out and the bottle or jar can be
removed.
8. Shake the bottle slightly or stir the food in the jar with a spoon to check the bottle or
jar contents, as described in "To check the temperature", before feeding the baby.
9. If the temperature is too low, you can leave the bottle or the jar in the baby food war-
mer for a few minutes without switching the controller on again, since the remaining
heat keeps bottle or jar warm.
Important! Always set the rotary controller to OFF after use, remove the device plug
from the socket and pour the water out of the baby food warmer.
5. HEAT RETENTION FUNCTION
The baby food warmer keeps baby food warm for a certain period of time. Simply leave the bottle or jar
in the device after warming up and set the rotary controller to .
Attention: for microbiological and hygienic reasons, baby food should not be kept
warm for longer than one hour.
6. C ABLE WINDING
The device has a useful cable winder on the underside. The power cable can be wound up neatly after
using the device, saving space as well.
10
– device is switched off
– keeping milk bottles or food jars warm
– warming up milk bottles
– warming up food jars